[rsbac] (no subject)

[Matthias Jaenichen]

Sorry, litte typo:

it is SOFTMODE.

Add rsbac_softmode to your command line in lilo config to enable it

Reg.
Matthias
At 17:02 07.03.2004, webby wrote:
>What parameter do I put for lilo to start with safemode ebabled?
>
>Thank you
>
>-----Original Message-----
>From: rsbac-bounces at rsbac.org [mailto:rsbac-bounces at rsbac.org]On Behalf
>Of Matthias Jaenichen
>Sent: Sunday, March 07, 2004 9:46 AM
>To: RSBAC Discussion and Announcements
>Subject: Re: [rsbac] (no subject)
>
>
>At 14:05 07.03.2004, webby wrote:
> >I have to install rsbac remotely. therefore after rsbac is installed. I can
> >not log in using ssh due the fact the ssh can't change owner. not permitted
> >by rsbac. I have the following though.
> >
> >install rsbac on the remote host. Before I reboot the machine, I upload the
> >config file to the server, (it is the dir /rsbac.dat, isn't it) and then
> >reboot the machine. I hope after the reboot rsbac can use that settings.
> >
> >any body has a better idea?
>
>Yes, compile with safemode and have safemode enabled via boot options.
>reboot
>configure RSBAC until all "denied"s are gone.
>
>
>_______________________________________________
>rsbac mailing list
>rsbac at rsbac.org
>http://www.rsbac.org/mailman/listinfo/rsbac
>
>
>_______________________________________________
>rsbac mailing list
>rsbac at rsbac.org
>http://www.rsbac.org/mailman/listinfo/rsbac